Materials Managing Power UNIT 1
Basic Description
This electrical power unit is developed to the fork lift sector, consisting of really productive gear pump, DC motor, guide increase and reduce valve, tank, ect. The up and down motion are controlled by the lever with the guide release valve, that is outfitted with an electrical switch to activate the motor. The lowing speed is controlled through the pressure compensated flow handle valve.
Special Notes
1. The duty of this energy unit is S3, i.e. thirty seconds on and 270 senconds off.
2. Clean the many hydraulic elements concerned ahead of installation of the electrical power unit.
three. Viscosity of your hydraulic oil 
shoud be 15~46 cst, which ought to also be clean and no cost of impurities, N46 hydraulic oil is suggested .
4. Oil altering is required following the preliminary a hundred operation hours, afterwards as soon as each 3000 hours.
five. The electrical power unit shown is created to be mounted horizontally.
Materials Managing Energy UNIT two
Standard Description
This electrical power unit features power up gravity down circuit. Activate the commence solenoid to start out the motor to lift the machine. The lowing motion is activated by the solenoid valve using the lowering velocity controlled from the strain compensated flow control valve. Solutions of this series could be extensively utilized in the sector of logistic units including fork lift, mini lift table, etc.
Particular Notes
1. The duty of this power unit is S3,i.e.,30 seconds on and 270 senconds off.
two. Clean every one of the hydraulic elements concerned just before mounting the electrical power unit.
3. Viscosity of the hydraulic oil shoud be 15~46 cst,which should really also be clean and free of charge of impurities, N46 hydraulic oil is advisable .
four. Oil modifying is needed just after the initial one hundred operation hrs,afterwards when every 3000 hrs.
5. The power unit must be mounted horizontally.