Select Page

SMR Gearbox Installation
Satisfactory effectiveness relies on correct set up. lubrication and maintenance. thus it’s important the guidelines while in the set up and upkeep leaflet. provided with every single gearbox. are followed carefully. several of the important aspects of belt and torque-arm installation are listed below.
one. Install pulley on gearbox input shaft as near to the reducer possible, and mount reducer on driven shaft as close to bearing as useful. failure to accomplish this will likely trigger extra loads during the input shaft bearings and output bearings and could result in their premature failure.
2. Install motor and wedge belt drive using the belt pull at somewhere around 90° to your center line involving driven and input shafts. this will likely allow tensioning on the wedge belt drive using the torque arm which need to preferably be in stress. if output hub runs anti-clockwise. torque arm needs to be positioned the appropriate.
three. lnstall torque-arm fulcrum on the rigid help so that the torque-arm might be at roughly right angles to your center line with the driven shaft and the torque arm situation bolt. ensure that there is sufficient get up during the turnbuckle for belt stress adjustment.
Preserve shut.
Bell drive might be positioned in any easy postion. in the event the torque arm will be to be utilised to tighten the belts, the drive must be at about tight angle to the line concerning the input and output shafts.
Bell drive may very well be positioned to the right if preferred.
If output hub rotates clock-wise. place belt drive and torque arm in opposite path to that shown inside the illustration.
Torque arm and belt consider up.
Torque arm can be mounted to your proper if preferred.