Electrical power UNITS FOR LIFT TABLE one
Standard Description
This energy unit is made exclusively for that compact lift table,Consisting of large pressure gear pump, AC motor, multi-functional manifold, valves, tank, etc. This energy unit has become extensively employed inside the sector of logistic units which include minifork lift, scissors lift and ariel operating platforms. The lower-ing movement is managed through the solenoid valve with all the speed managed through the adjustable needle valve.
Power UNITS FOR LIFT TABLE two
Basic Description
This energy unit is built exclusively for the medium lift table, Consisting of highly effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering motion is actived through the solenoid valve as well as pace managed through the adjustable needle valve. When the lift rises to a high positoin, but the power provide is minimize, the reducing movement is controlled by the manual override perform.
Power UNITS FOR LIFT TABLE 3
Basic Description
This electrical power unit is developed solely to the big lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived through the solenoid valve and the velocity managed by a stress compensated movement control valve.
Power UNITS FOR LIFT TABLE 4
Common Description
This electrical power unit is 
developed solely to the huge lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived through the solenoid valve as well as the pace controlled by the adjustable needle valve. Once the lift rises to a large positoin, but the power provide is lower, the decreasing motion is controlled from the manual override function.
Specific Notes
one. This power unit is of S3 duty cycle, which may only do the job intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean all of the hydraulic elements concerned just before installation of the electrical power unit.
3. Viscosity of your oil shoud be 15~46 cst,which really should also be clean and totally free of impurities.N46 hydraulic oil is advised.
four. Oil altering is required immediately after the first 100 operation hrs,afterwards once every 3000 hrs.
five. The electrical power unit shown is built to be mounted vertically.
