Select Page

1.A connecting hyperlink of an O-ring Chain for general application is pre-coated with grease in the pins. In advance of connection, confirm the grease about the surfaces of pins, and in the event the volume of grease is smaller, apply grease with bare hands. (If gloves are used, the grease is going to be absorbed by the gloves.)
Illustration: Once the connecting link (I) of an O-ring chain for common application is
shipped, O-rings are fitted on the roots of the pins. If your O-rings come loose due to vibration in the course of transport, refit the O-rings in towards the roots of your pins.
In this instance, be sure you return the grease collected with the roots of the pins towards the central surfaces of the pins, far more at portion A than at portions B proven from the over illustration. (Portions A is worn as a consequence of sliding using the bushings.)
2.The chain might be most effortlessly connected within the teeth of the sprocket. Engage the back links at the two ends with the chain with the sprocket teeth and fit connecting pins. When the sprocket can be moved, the chain may also be linked on the loosened side.
three. Connecting method
1.Verify that O-rings are connected to your roots in the pins.
2.Should the amount of grease applied over the connecting pins is little, coat the pins with grease with the central portions.
3.Insert the connecting pins in to the bushings of the inner backlinks at the two ends.
four.Confirm the grease is applied to your entire face of the O-ring, and fit the O-ring onto the connecting pins.
five.Insert the connecting pins to the connecting plate and while pressing the connecting plate, install the spring clip. Confirm no matter if the head (the finish without a split) from the spring clip is turned during the feeding direction in the chain. (See the next illustration.)
6.You should definitely verify the spring clip is securely fitted during the clip grooves of your connecting pins.
This completes jointing on the connecting website link. Note that grease over the surfaces of connecting pins and O-rings may be eliminated through installation do the job. In this instance, re-grease working with the grease around the surface with the base chain or the grease inside the polyethylene bag through which the connecting website link was contained.